KitchenAid Range

KitchenAid KERC507HWH

Model # KERC507HWH

The KERC507HWH is a KitchenAid range. What KitchenAid published about the KERC507HWH is that it is a 30″ Freestanding Electric Range with Ceramic-glass Cooktop, and that single line is all the specification there is. It sat in KitchenAid’s US catalogue from February 2000 until October 2003, which is the window the archive records.

A KERC507HWH still in a kitchen today has twenty-odd years behind it, and that age shows first in the door seal, the oven sensing and the surface controls. Being out of production, a KERC507HWH has its parts position checked at the outset rather than after a diagnosis.

Key Features

  • 30" Freestanding Electric Range with Ceramic-glass Cooktop
  • Recorded on KitchenAid's US product site from February 2000 to October 2003
  • No rating-plate revision code was observed for this model

Most Common Issues on This Model

01

A thermal fuse tripped after self-clean, leaving the oven without power while the surface still works

02

Oven lamp, lamp holder and switch failures

03

A cooling fan running constantly, or not running at all

04

Storage or warming drawer runners worn, so the drawer binds

Error Codes Common to This Model

Own This Model? We Know It Well.

Book a technician who has already diagnosed and repaired this exact model dozens of times.

FAQ

KitchenAid KERC507HWH FAQ

The plate inside the oven's door carries everything needed: the full KERC507HWH model string and the serial number beside it. With those two, a part for a KERC507HWH can be identified before anyone travels out, which saves a wasted visit.

The KERC507HWH is out of production, and whether repair beats replacement comes down to which component has gone. A seal, a switch or a control is usually straightforward economics on a KERC507HWH; a major assembly on a machine of this age often is not, and we will say which one you are looking at.

With the range switched off at its supply, the oven temperature sensor on a KERC507HWH is the first part measured, because a drifted sensor makes the control heat to the wrong figure. Only once the sensor on a KERC507HWH has been proved are the heating components considered.

Need a repair? We're ready to help. Call Now
Call Us Schedule