What Feature Not Available or Fault Detected Means
Freestanding and slide-in Range: KitchenAid publishes this as a scrolling message with a specific trigger: it will scroll across the display when a fault is detected while you are programming a cook cycle. The timing is the useful part - the range was not mid-bake, it was being told what to do, and something about that instruction or the state of the appliance did not check out. The page tells you to follow the displayed directions, quoting two of them, and then gives the standard power reset.
Common Causes of Feature Not Available or Fault Detected
- A fault detected at the moment a cook cycle was being programmed
- A feature selected that is not available in the current state of the range
- An underlying fault that shows itself when the range is asked to commit to a cycle
🔧 One Safe Check You Can Try
Let the oven cavity and the cooktop cool before you do anything, and put every surface knob at off. A range holds heat in its grates or its glass long after the controls are off. Follow whichever instruction your display is actually showing, since the two KitchenAid quotes ask for different things - one to try the entry again, the other to remove power to clear. If the message persists, power the range down by switching off its circuit breakers for one minute, power it back up, watch it for one minute to be sure the code does not return, and verify the range operates and then start a bake cycle and watch it for a minute. Note which feature you were programming when it appeared, because a message tied to one function is far more useful than one with no context.
⚠ Why You Shouldn't Go Further Than That
- Nothing is named, so the message supports no parts decision, and the feature you were setting is better evidence than the words on the display.
- A range that rejects programming intermittently may accept it at other times, and a cycle that starts on an appliance which just reported a fault is a cycle worth watching.
- On a gas model the supply line and its shut-off are behind the range, so moving the appliance means the gas off first and the connection tested afterwards - not an owner step.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.