The KCDC250K belongs to KitchenAid’s US dishwasher catalogue. No published specification for this model was recovered. What survives is the model number and a dated record of when KitchenAid was showing it, and that is what is set out here. The archive of KitchenAid’s US product site holds it from November 2001 through to December 2005, and no later capture carries it.
By now a KCDC250K is an old machine, and the door seal, the pump and the spray system carry most of the wear. Discontinued does not mean unrepairable, but it does mean availability of the specific part for a KCDC250K is established before any figure is put on the job.
Key Features
- No published specification for this model was recovered
- Recorded on KitchenAid's US product site from November 2001 to December 2005
- No rating-plate revision code was observed for this model
Most Common Issues on This Model
An inlet valve stuck part open or failed shut, so the machine either overfills or never fills
Filter and sump blockages, the commonest reason for poor drainage and a smell from the tub
A float switch held up, which the control reads as an overfill and stops the cycle
Control board and touch panel faults after years of steam and heat cycling