What 1 Pause 1 Pause - pause, repeat Means
Dishwasher: on a model without a digital readout, KitchenAid reports faults by blinking a light, and it publishes the sequences as pages in their own right. This one - one flash, a pause, then one flash again, then the whole thing repeats - is the blink form of F1E1, and KitchenAid gives it the potential cause "Control Module". The control module is the board that runs the cycle from fill through to drain, and the code says it failed one of its own checks. KitchenAid publishes the way to read these: count the first set of rapid flashes for the Function number, watch for a short pause of about one to two seconds, count the second set for the Error number, then wait through a longer pause of about five seconds before the whole sequence repeats.
Common Causes of 1 Pause 1 Pause - pause, repeat
- The condition KitchenAid publishes for F1E1, which is control module
- A fault the control caught during its own checks rather than one you could see
- A miscounted sequence, which is worth ruling out by watching several repeats before acting
🔧 One Safe Check You Can Try
Before you count anything, stand where you can see the light clearly and watch two or three full repeats, because a miscount by one flash sends you to a completely different fault. Once you are sure of the sequence, treat it exactly as you would the displayed code: the published response for F1E1 is the standard thirty-second power interruption. If the dishwasher is on a cord, unplug it for thirty seconds and plug it back in; if it is hard-wired, switch the breaker that feeds it off at the household panel, leave it off for thirty seconds, then switch it back on. Then watch whether the same pattern comes back.
⚠ Why You Shouldn't Go Further Than That
- A board that cannot be trusted to sequence a cycle is not a part to guess at, and the control sits behind the door panel beside line-voltage latch wiring.
- A blink sequence read wrongly sends a technician after the wrong system, so the count matters more here than on a machine that prints the code out.
- Everything this code refers to is behind the door panel or under the tub, and neither is opened while the machine is connected to power and water.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.