KDTM404EBL Repair | KitchenAid Appliance Repair

KDTM404EBL is one of the dishwasher model numbers KitchenAid carried in the United States. No published specification for this model was recovered, and none is invented here to fill the space. It was on KitchenAid’s US product site from September 2015 to August 2017 and gone after that.

That puts a KDTM404EBL roughly ten to fifteen years into service, the point at which the door seal, the pump and the spray system tend to need attention. The KDTM404EBL is no longer made, so what can actually be obtained for it is the first thing looked at, not the last.

Key Features

No published specification for this model was recovered
Recorded on KitchenAid's US product site from September 2015 to August 2017
A KitchenAid owner's manual for this model is on record

Most Common Issues on This Model

01

A float switch held up, which the control reads as an overfill and stops the cycle

02

Control board and touch panel faults after years of steam and heat cycling

03

Rack rollers and rail wear, so a loaded rack drops or jams halfway out

04

A detergent dispenser flap that no longer opens at the right point in the cycle

Error Codes Common to This Model

Own This Model? We Know It Well.

Book a technician who has already diagnosed and repaired this exact model dozens of times.

Call (844) 405-1464 Schedule a Visit

FAQ

KitchenAid KDTM404EBL FAQ

For a KDTM404EBL, look on the left edge of the dishwasher's door. That is the location KitchenAid publishes for its dishwashers, and the label there is the authoritative source for the number - front-panel badging and box labels often differ from what is actually on the KDTM404EBL.

Sometimes, yes - a discontinued model like the KDTM404EBL can mean waiting on a specialist supplier for an obsolete part. We establish that on a KDTM404EBL before the job starts, so the choice between waiting, substituting where a substitute genuinely exists, and replacing the machine is yours to make with the facts in front of you.

Almost always the filter, the sump and the drain hose rather than anything electrical. With the dishwasher switched off at its supply, those parts of a KDTM404EBL can be cleaned by hand. A KDTM404EBL that still smells after that usually has a drain hose sitting low enough to hold standing water.

KitchenAid KDTM404EBL

Key Features

Most Common Issues on This Model

Error Codes Common to This Model

F9E2

Sanitize Light Flashing

FAE4 or F10E4

FAE5 or F10E5

1 Pause 1 Pause - pause, repeat

6 Pause 1 Pause - pause, repeat

Own This Model? We Know It Well.

KitchenAid KDTM404EBL FAQ