A KDTM384ESS that won’t start with the door apparently shut usually has a failed latch switch rather than a misaligned latch.
KitchenAid KDTE404DBL
A rising whine that builds through the cycle on a KDTE404DBL is the wash motor bearing wearing, well ahead of any actual motor failure.
KitchenAid KDTM404EBL
After years of steam and heat, the control board and touch panel are a common early wear point on a KDTM404EBL.
KitchenAid KDTE404DSP
A KDTE404DSP that halts mid-cycle as though overfilled, even with a normal water level, usually has a float switch stuck in the raised position.
KitchenAid KDTM404EBS
Water on the floor in front of a KDTM404EBS after a cycle, rather than a full flood, is the telltale sign of a door seal that has gone hard and stopped sealing evenly.
KitchenAid KDTE404DSS
A door that won’t latch is a common complaint on the KDTE404DSS, and more often than not the switch behind the latch has failed rather than the latch mechanism itself.
KitchenAid KDTM404ESS
A rack that drops or jams on a KDTM404ESS is usually down to worn rollers or rails rather than anything wrong with the rack itself.
KitchenAid KDTE504DSS
After years of heat and steam, the control board and touch panel on a KDTE504DSS are among the parts most likely to start acting up, sometimes years before any mechanical part fails.
KitchenAid KDTM504EPA
A drain pump that hums without actually clearing the sump is a recurring complaint on the KDTM504EPA, usually down to debris jamming the impeller.
KitchenAid KDTE554CSS
A drain pump that hums without actually clearing the sump is a recurring complaint on the KDTE554CSS, usually down to debris jamming the impeller.