
Worn control knobs and shafts on a KECC508RPS show up as a setting that no longer matches where the dial actually points, and the knob and shaft underneath it are checked together since a worn shaft is not fixed by a new knob alone. A zone that shuts off sooner than expected instead points to the thermal limiter reacting to heat under the glass.
Key Features
- Sold around 2010
- Rating-plate revision codes observed for this model: KECC508RPS03
- A KitchenAid owner's manual for this model is on record
Most Common Issues on This Model
Control knobs and their shafts worn, so the setting no longer matches the mark on the panel
A thermal limiter cutting a zone early because the glass beneath it is running hot
An induction zone that refuses to recognize a pan, where an induction surface is fitted
A cooking zone that no longer heats while its neighbors work normally