Sagging doors from worn hinge cams are common on the KSSS42MD, keeping the seal from meeting the cabinet squarely even with a good gasket. Electronic control failure is the other, more serious issue — the machine keeps running, but the panel no longer answers.
KitchenAid KSSP48QFS
A defrost cycle that has stopped running is a frequent cause of trouble on the KSSP48QFS — once it stops, ice builds up behind the freezer back panel until the airflow the fresh food side depends on is choked off completely. Sagging doors from worn hinge cams are the other thing to check, since they […]
KitchenAid KSSS42MDX03
A control board that has aged out of service is the part most worth checking on a KSSS42MDX03 that no longer follows its settings correctly. A control reading the cabinet wrongly is a related but separate issue, causing the compressor to run far longer or far shorter than it should.
KitchenAid KSSP48QFW
Evaporator fan motor noise is common on the KSSP48QFW, and once the fan stops altogether the fresh food side can climb in temperature while the freezer stays cold. Restricted condenser airflow is the other frequent cause of a cabinet that slowly loses its grip on temperature, usually from coils that have not been cleaned in […]
KitchenAid KSSP42MF
Loss of refrigerant charge is the issue that most affects whether a KSSP42MF is worth repairing, since the cost depends on where the leak is. Defrost drain freezing solid is a separate, cheaper problem, sending meltwater under the crisper drawers instead of down the drain.
KitchenAid KSSP48QJS
Control board problems are common on the KSSP48QJS after many years of service, showing up as a cabinet that no longer answers its own settings. Cold control or thermistor drift can cause a similar-looking problem, so we check both before assuming which one is responsible.
KitchenAid KSSP42MFB05
A condenser fan that has seized or slowed is a common cause of poor cooling on the KSSP42MFB05, especially in warm weather. Door hinge and closer wear is the other issue to check, leaving the door sitting proud instead of swinging fully shut.
KitchenAid KSSP48QKS
Temperature sensing drift is a common issue on the KSSP48QKS, leaving the cabinet unable to settle on a steady reading even with the dial untouched. An interior lamp that has failed, or a door switch that no longer registers the door shut, is the other complaint we hear, and either one is a quick fix […]
KitchenAid KSSP42MFW05
Compressor start relay and overload problems are common on the KSSP42MFW05, often heard as a click every few minutes with no cooling ever following it. Electronic control failure is the other issue to check, where the cabinet keeps running but the panel no longer answers.
KitchenAid KSSS36FJW
Lighting and door-switch problems are worth ruling out on the KSSS36FJW before assuming anything is wrong with the cooling system, since a stuck switch can look like a cooling complaint. Sealed-system problems are the more serious possibility, and if that is what’s found, it is identified plainly rather than repaired around.