KitchenAid KECC502GWH

Worn control knobs and shafts are a common owner complaint on the KECC502GWH, showing up as a setting that no longer matches the mark on the panel, and the knob and shaft are checked together since replacing only the knob rarely fixes it. A zone that cuts out earlier than expected instead points to the […]

KitchenAid KECC562GWH

A KECC562GWH with one completely dead zone next to working ones is checked at that zone’s own switch and connection first, since the working zones rule out a shared cooktop-wide problem. Where a zone instead runs at full heat no matter the knob position, an infinite switch has failed closed and needs replacing.

KitchenAid KECC506R

If the flame on a KECC506R will not stay lit at a low setting, the gas valve itself is usually not holding that setting, and it is inspected and adjusted on the bench rather than from the knob. Years of heat cycling can also damage the wiring beneath the cooktop, which is liner-level work left […]

KitchenAid KECC563HWH

A cracked or chipped glass surface on the KECC563HWH is treated as a safety matter, since it no longer reliably separates the elements from anything spilled above, and the cooktop should be kept off until it is repaired. Touch controls that respond only intermittently point instead to the panel or its control board rather than […]

KitchenAid KECC506RSS

A cracked or chipped glass top on the KECC506RSS is a safety matter rather than cosmetic, since the surface no longer reliably keeps the elements separate from anything spilled on it, and the cooktop should stay off until it is repaired. Touch controls that only work some of the time point instead to the panel […]

KitchenAid KECC566RSS

Where a KECC566RSS has a downdraft vent built in, a motor or damper that has stopped pulling air is repaired as part of the cooktop, and a blocked duct run is ruled out before either part is replaced. A flame that drops out when turned down low is unrelated — that points to the gas […]

KitchenAid KCGS950ESS

A crack or chip in the glass on a KCGS950ESS is treated as a safety issue rather than cosmetic damage, since the surface is what keeps the elements separated from anything spilled on top, and the cooktop should stay off until it is dealt with. Touch controls that respond intermittently point to the panel or […]

KitchenAid KCGS956ESS

Where a KCGS956ESS has a built-in downdraft system, a vent that has stopped extracting is diagnosed as part of the cooktop rather than a separate appliance, since the motor and damper are specific to that model. A flame that drops out whenever it is turned low, on the other hand, is a gas valve not […]

KitchenAid KECC051H

A zone on the KECC051H that will not back off from full heat regardless of the knob position has an infinite switch stuck closed, and it is replaced rather than adjusted since it will not respond to the control in the meantime. A cracked or chipped glass surface, by contrast, is a safety issue that […]

KitchenAid KECC051HBT

A hot-surface light on the KECC051HBT that stays lit well after the surface has cooled points to the indicator circuit itself rather than an actually-live element, and that is tested with the cooktop cold before anything is replaced. Where this model has a downdraft vent, a motor or damper that stops pulling air is repaired […]

Need a repair? We're ready to help. Call Now
Call Us Schedule