A cracked or chipped glass top on the KECC506RSS is a safety matter rather than cosmetic, since the surface no longer reliably keeps the elements separate from anything spilled on it, and the cooktop should stay off until it is repaired. Touch controls that only work some of the time point instead to the panel […]
KitchenAid KECC566RSS
Where a KECC566RSS has a downdraft vent built in, a motor or damper that has stopped pulling air is repaired as part of the cooktop, and a blocked duct run is ruled out before either part is replaced. A flame that drops out when turned down low is unrelated — that points to the gas […]
KitchenAid KECC507HSS
Where a KECC507HSS has a downdraft system built in, a vent that stops extracting is repaired as part of the cooktop rather than treated as a separate appliance, since the motor and damper belong to this specific model. A flame that drops out when turned down low points instead to the gas valve not holding […]
KitchenAid KECC567G
The KECC567G is a 36-inch five-zone ceramic-glass cooktop, and a zone stuck delivering full heat regardless of the knob points to an infinite switch that has failed closed and needs replacing outright. A cracked or chipped glass top is a separate, more urgent problem, since the surface keeps the elements away from anything spilled on […]
KitchenAid KECC507KSS
A zone on the KECC507KSS that runs at full heat no matter the knob setting has an infinite switch stuck closed, and it needs replacing outright since it will not respond to the control until then. Cracked or chipped glass is a separate and more urgent problem, since the surface is what keeps the elements […]
KitchenAid KECC567GAL
The KECC567GAL is the same 36-inch five-zone cooktop as the KECC567G in a different finish, and worn control knobs are a common owner complaint on either one — the setting no longer matches where the dial actually points. A zone that cuts out sooner than expected instead points to the thermal limiter reacting to heat […]
KitchenAid KECC507KWW
A hot-surface indicator on the KECC507KWW that will not go out even once the surface has cooled points to the indicator circuit itself, and that is confirmed with the cooktop cold before any part is replaced. Where this model has a downdraft vent, a motor or damper that has stopped pulling air is repaired as […]
KitchenAid KECC567GBL
A hot-surface light on the KECC567GBL that will not go out even once the surface has cooled points to the indicator circuit rather than an actually-hot element, and it is confirmed with the cooktop cold before anything is replaced. Where this model has a downdraft vent, a motor or damper that stops pulling air is […]
KitchenAid KECC507RSS
A single dead zone on the KECC507RSS, with its neighbors still heating normally, is checked at that zone’s own switch and wiring before anything else is considered. A zone that instead runs at full heat regardless of the knob points to an infinite switch that has failed closed.
KitchenAid KECC567GBT
A cracked or chipped glass top on the KECC567GBT keeps the cooktop out of service until it is repaired, since the surface is what separates the five elements from anything spilled above them. Touch controls that respond only intermittently are a separate issue, usually traced to the panel or its control board rather than the […]